Creality CR-10 extruder front mount

thingiverse

This is based on the version by Penberic but I wanted it to look more like the original part and be able to use the original screws. I used 100% infill for this structural part as it will hold both X axes and your extruder in place. Some minor changes were made, mainly to the endstop, which now uses the original screws. If you print this version, you'll need to provide your own screws for the end stop. However, it works well. A filament guide will be added soon. EDIT: A filament guide was added two versions - one short and one long. The short version is very close to the printer while the long version is inline with the extruder. You'll also need a pinch roller that typically comes as a spare part. Photos are of the short version. Edit: A new version of the mount has been created. The only change made was to design the endstop to use the original screws, eliminating the need for extra bolts. The previous version required 2x M3 bolts to secure the end stop micro switch in place. Don't forget to adjust your belt tension after installation.