Creality Bondtech BMG/ V6 /Volcano /BLt All Fixed 2021

thingiverse

This is for the Creality Bondtech BMG/ V6 direct drive set up by Hangtight found here - https://www.thingiverse.com/thing:3241793 My remix of the duct is to add structural support now making it much more rigid and also adding another screw point to keep the 5015 fan from slipping out. I may work on the duct flow in the future as it tends to blow air behind the nozzle and not low enough. I would like it to blow directly below the nozzle at more an angle so the duct can be adjusted better and out of the way rather than extremely low. Update 12-13-2021 : After working with this awesome design for a couple of weeks I found a few more issues and have added the files to keep them in one place for reference. - Added a duct to better fit a volcano duct that is slightly extended and also aiming more downwards. - Added a BLTouch mount for volcano that is fixed from a previous remix but was too narrow to fit properly on the mount. It is widened and now fits much better. - I found the holes on the main mount were too small to sit completely flush around the screws for the guide wheels. Was initially confusing me on why I was having print issues. It is now fixed. May have worked for older enders as the original is years old now. Thanks for the initial design HangTight. No way I have skills to make something like this from scratch yet. Best looking mount and duct available. This design was the best I found that keeps a compact bmg direct drive setup for creality machines that does not need unnecessary large heatsink fans and a single 5015 fan. I also like the design because it leaves a void in the duct that the heater block is fully visible while printing.