Creality 3D CR10 Heat bed cable support and corner Guides for stock glass bed (Tight fit) No play on the corner parts.

thingiverse

I wasn't too keen on just the heat bed cable support on one corner - it looked alone, so I made a full set of corner pieces that make as little contact with the bottom of the heat bed as possible. They also help stop the springs underneath from digging into the heat bed over time. 1x Heat Bed Support (with cover) needs two small zip ties. 3x Corner Guides for the stock glass bed, with no play (wobble) in the parts. They will fit and hold the glass tight, stopping it from sliding around when the clips are removed. They help guide the glass bed into place. I still use the 4 small clips to hold the glass flat though - my glass is pretty flat and I have forgotten to add the clips on some prints and they've turned out okay. Not sure if the IKEA mirror will fit as I don't have one yet.