Crawler Body Mount for Absima Ab2.4 At2.4 Mt2.4

Crawler Body Mount for Absima Ab2.4 At2.4 Mt2.4

thingiverse

The Abismo Ab 2.4 is a decent buggy, but its ugly design is a major turnoff. So I designed a body mount that fits a cheap crawler body. You can easily recycle a really rock crawler or similar vehicle from various brands selling the same RC car. No modifications are needed for your Absima buggy/truggy! Just use the main part of the rock crawler body, and you can keep the interior if you trim the bottom. Installation: Mount the rear bottom part (Karohalter_hinten_bottom) to the stock damper bridge with 4 M3 screws and nuts. The top rear part (Karohalter_hinten_top) clamps the rear boom of the body with three M3 screws. Now you can open and close the body like a door without disassembling anything for service. Mount the front lower part (Karohalter_vorn_V2) to the front differential, don't forget to insert the M3 nuts into the bottom side. Then mount the upper Part (Karohalter_vorn_V3_top) onto the lower Part. Use a drill to open the holes of the body above the new mount to 6mm diameter. Now you can insert standard 6mm body posts and close the whole vehicle with two body clips. It's easy to open and close. I added a switch mount for the Hobbywing Ezrun 120A, which is located on top of the ESC fan and is accessible in front of the passenger seat. Have fun printing and upgrading your buggy! It should work for the AT2.4 Truggy as well, but I'm not sure about the MT2.4 Monster Truck since it has another damper setup.

Download Model from thingiverse

With this file you will be able to print Crawler Body Mount for Absima Ab2.4 At2.4 Mt2.4 with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Crawler Body Mount for Absima Ab2.4 At2.4 Mt2.4.