Crash Bandicoot - Controller Stand >REMIX< Less support and straight joints

thingiverse

Less supports and better joints since all joint surfaces is facing the bed except 1 and not supported that can leave edges. Only downside is that the arms and hands on the upper side are suffering from the supports, but could not see a better solution in this case. Legs can be printed without supports, but a little sag will appear on the lower part of pants. Body needs support inside of the mouth and some in the hair. I used a dot of support at the very beginning of the nose too. Arms will need supports in the whole hand and a bit on the arm, if u decide to orientate the joint to the bed ofcourse. The cubes may need to scale down or up. depends on the printers quality, thats why i left them loose and not attached to model.