Crappy Piggy Bank V2

thingiverse

Second version of my crappy modelV2 is with better models (optimized, some parts redesigned etc.) and with more options - more about changes below- BANK - as piggy bank, flush is opening the seat - default and recommended settup- SECRET - normal box with another secret stash under top cover - no hole for coin- BANK-no-flush - as piggy bank without opening mechanism- SECRET-no-flush - same as SECRET but without a flush and with more space in secret stash- BANK-SOLID - solid model of piggy bank, only one part. You will need to break it to gather coins from the inside. - WARNING: print needs a good cooling to look goodAll models, except BANK-SOLID, is also in BIG version wich is optimized 150% size of original model - better resolution, with walls still the same thickness as original (wich is 4x 0.4mm). You can resize it bigger if you wantIf you want a model between 100% and 150% size you should resize original model up, not BIG model downYou will need a 1cm of 1.75 filament for each hindge. It will work without any glueOR two printed rods (in files)You can use SECRET with a cover with a hole (BANK_cover) to use as a small piggy bank and bigger storage under seat for something elseThere are 4 versions of coverwith hole for coins (BANK_cover)without any hole (SECRET_cover)with big hole (BANK_cover-big-hole) - as big as space belowwith even bigger hole (BANK_cover-big-hole_no-flush) - to use with no-flush version of baseLast two can be used to store something bigger than coins in this Toilet Box (without the need of opening the seat)Seat is in two versions, original, more rounded, and streight wich is more ‘blocky’ but elegantIn ‘ALL’ there is original modelNo-flush base models can be used only with no-flush seat modelsPrinted spring is not needed for mechanism to work, but it may help a little. You can change it for a spring from a pen too if you wantVideo with printing timelapse, assembling and usinghttps://www.instagram.com/p/Cz4FUv5NW8R/V2 vs V1now it's easier to print (smaller angles of overhangs)a lot more models (including BIG version)flush is not blocking the closing of the seat so it's harder to break something - this may be a pros or con, dependa on what you want and if it's for a kid or adultdifferent hinge - now it uses filament or printed rod - will be much tougherwall thickness is pretty the same around the model wich will lead to cleaner printmore space inside for coins or other thingsother smaller improvementsUPDATE 23 XI 2023Added 2 new versions of cover with bigger hole (as big as space below)UPDATE 24 XII 2023Added a photos of BIG printUpdated BIG_seat models. It was not completely flat so it could cause imperfections on top layer