Cranosaurus

prusaprinters

Cranosaurus (Dźwigozaur)Original size: ~21cm tallStanding crane model for assemblingAnimation of how to assemble:https://youtu.be/t5jVspsCsL4Short instruction is on the photo---The only thing you will need, exluding printed parts, is a thread to connect a wheel-big and a hookNames of STL files are with quantity of how many parts you will need, not how many there is in the file'all main parts' file is for printers with at least 19x19cm bedIt is without pins, wheels, hook, rings, slider and base_load (this one is to add more weight to base, if needed, to pull sth up with a crane)Pins 'fat' are for good accuracy printers / smaller nozzle (than 0.4) / specific options in slicer. - where normal pins can be too small.First, print one normal size pin170 and a 'ring' and test it. Some force should be needed to put pin in but then it should rotate easly - if the pin will be too small try 'fat' file, then if it is too big resize it in slicer a little [turn off uniform scaling and set X and Z to like 90%, leave Y with 100%]If you will have some questions just ask in the comment---Prepared for 0.4mm nozzleNo supports neededPins and wheels should be printed with 0.1mm layer height or lower and rather slow speedPET-G recommended for itRest can be printed with 0.2mm with PLAPins should have 100% infill. 'Fill gaps' slicer option may be usefull