Crankbait 14cm, WIP

thingiverse

Work in Progress: My current project is around 14cm long, excluding the lip, and the lip cutout measures 3mm wide. I recently conducted a test print with a 5% infill setting to experiment with my airbrush techniques. However, I'm still searching for an efficient way to incorporate a trough-wire into the design. To address this issue, I added a new model that features a pre-drilled hole or cutout specifically designed to accommodate the wire. Additionally, I created a designated area for adding weight; however, I believe it requires some refinement in its current form. My first print attempt was successful after using support at 35% infill and a raft, as the initial attempt failed to adhere properly to the bed. In most cases, a raft is not necessary.