Crane Fly

thingiverse

Warning: Brushless motors can get extremely hot, which isn't ideal for printed plastic! I'd love to see the motor mounts made from heat-resistant materials, but as a standard 3D print, they'll likely warp if you crash with the motors running at full speed. I've created custom inner voids so you can print at 100% fill density. To assemble this model, lay out all the rods and parts and slowly work everything inward. Use a spot of hot glue to secure the camera and attach the rods in place. Use hot air to clean up any excess glue and smooth out the surface. I initially experimented with using a heated pin on each side to fix the camera, which is why there are two small holes. Parts List: * 8.5x20mm Coreless Motors * Micro 32bits F3 Brushed Flight Control Board Based On SP RACING F3 EVO Brush For QX95 QX90 QX80 * Walkera QR Ladybird Blades Propellers for Eachine QX95 QX90 * DasMikro Ultra Miniature PPM Signal Output 8CH Receiver * 2mm Diameter Carbon rods (40.5mm x 4 / 58mm x4) * FX798T 5.8G 600TVL 25mW 40CH NTSC Mini Transmitter Camera Combo