Craftsman Screwdriver Holders - Gridfinity

prusaprinters

This Gridfinity based Craftsman screwdriver holder was made to allow you to print for each screwdriver separately to accommodate individual collections while conserving filament.  I didn't think the holder needed to house the entire screwdriver shaft and found that only the handle needed to be supported for this to work properly.  Magnet holes are included if you use them.  Each screwdriver is sized for the Craftsman screwdriver handle listed.  I have not tried every handle out there, just the ones I have.   Listed below are the files and Craftsman model. PH3 and SL ¼ Holder = CMHT65009 and CMHT65015PH2 and SL 3/16 Holder = CMHT65004, CMHT65005, CMHT65023, and CMHT65021PH1 Holder = CMHT65002PH0 Pocket Holder = CMHT650000Phillips Stubby Holder = CMHT65003SL 1/8 Holder = CMHT65018SL 1/8 Pocket Holder = CMHT65017Flat Stubby Holder = CMHT65013I printed mine using colors that coordinated with the handle colors (I ran out of red, don't judge me).  Printed at 0.2 layer heights, 3 walls, and 5% infill.