Craftbot door panel hinges
thingiverse
27.01.2015 Today I printed two sets of hinges, along with including simple step-by-step instructions for assembly. Instructions: Cut out hinges using Craftware Layer settings: 0.25, ABS plastic, raft only for "pin" To complete the door: Acrilic sheet 3mm thick, 380x300mm Two pairs of hinges Electric screwdriver or drilling machine for drill holes Bit: 3mm, 3.3 mm, and 8 mm (optional) Sandpaper Optional screws: 3x10mm Using a drilling machine, clean the holes to match their intended size. Use sandpaper to correct the pin if it measures greater than 3mm in diameter. Perform a quality check on the assembly; if issues arise, verify that the holes and pin are correctly dimensioned. Finally, drill a 9mm hole in the "wall" part, starting from the thin edge as shown in the attached photo.
With this file you will be able to print Craftbot door panel hinges with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Craftbot door panel hinges.