Cradle Remix - Smaller mounting hole

prusaprinters

<p>I really like the ferris wheel extruder indicator published here: <a href="https://www.prusaprinters.org/prints/29469-ferris-wheel-extruder-indicator">https://www.prusaprinters.org/prints/29469-ferris-wheel-extruder-indicator</a>.</p> <p>However, I found that the cradles were loose enough on the ferris wheel that they could fall off, potentially into my print. Therefore, I modified the cradle file slightly to make the hole snap on rather than just sliding on. I modified the original using TinkerCAD, and simply placed a torus centered on the original hole.</p> <p>Note: This file is not useful on its own. You will need the ferris wheel from the main print.</p> <p>Second note: You need a total of five cradles. I found it helpful to have one of them a different color to make the movement more obvious.</p> <h3>Print instructions</h3><p>Nothing special about the print except, as noted above, I found it helpful to make one of the cradles a different color. (You need five total.)</p> <p>Printed at 0.2 mm. Very quick print. I found that the cradles adhered fine to a clean print bed, but they are very small, so a brim might be helpful if you have trouble with them sticking.</p>