Cradle for Afterburner temperature sensor

thingiverse

Cradle for Chinese Diesel heater afterburner controller temp element. Has cut outs for the cable to come out the bottom left or right, or can just be fed straight out the bottom as needed. Bottom part should be attached in place and then the top part should pop into place and clamp the temp element in place in the middle. Care should be taken not put too much lateral pressure on the securing clips. I have made them as solid as i felt the could be while still working correctly but they've a habit of snapping off. (This could maybe be sorted by printing the part vertically, didn't try it myself though) I've located this in a camper van and printed in PTEG to be sure and prevent temp warping in the the summer months, but you could maybe get away with PLA - Nothing on it should be under much load at all.