CR6-SE Petsfang MicroSwiss Remix

thingiverse

I just extended it by 2mm so that the top of the blowers would be just at or under the Silicon Sock. In the process of printing to test it. Since this is my first remix I'm not even sure it'll work properly, so proceed on your own. Edit: Yellow is the Original Petsfang clone by Paroni. Purple Shiny, I don't recommend poor strength, is my remix. Don't think you can go any lower with it. It's got a lot of air going towards the back of the nozzle but I don't know if that's by design. Basically blocks the LED, only get some light cast directly downward. Currently printing a overhang test, again in the purple, to see if it helped.