cr10s v6 and volcano clone adjustable 4010 fan mount

cults3d

This is an adjustable stock cr10s (4010) fan mount for v6 clone hotend mount, check it out in my files. It offers excellent clearance and comes with adjustable slots that allow you to adjust the height for a v6 or volcano setup as needed. The 4010 fan simply slides into place without needing screws to secure it, although there are holes available if you prefer to use stock screws. I've personally run this mount without screws and haven't experienced any issues, even with the fan not moving at all. When printing this part, I recommend using supports. Be patient when removing these supports from the air duct, as it may take some time and care. I designed the part so that the component that attaches to the carriage rests directly on the print bed for easy assembly.