CR10s-PRO V2 Direct Drive Bracket Mod

thingiverse

Compared with my CR-10S PROV2, I made some adjustments 2.0version 1.Dig holes to reduce weight from 22g to 18g 2. Restore the stiffeners at the joint ========================================== 1. Reduce the thickness of the connection of the stepping motor, otherwise the screws of the extruder cannot be fully engaged, which will cause thread slippage. 2. The fillet at the connection is removed, which will affect the installation of the connection 3. The position of M4 threaded hole is adjusted so that the pneumatic joint of the extruder and the nozzle can correspond The biggest advantage of this MOD is that it does not need to change the air duct, fan head and automatic leveler. thx to @adjoneses The problem is 1. The strength of the connector is reduced, and it will shake when it is pulled back 2. There is no support for the material break detection temporarily. I will add a support position later to try 3. The weight of the entire print head has increased. If the printing speed is too fast, there will still be laminations