CR10s Pro (V1/V2) X Limit spacer for the Biqu H2 cradle

thingiverse

I upgraded my CR10S Pro V2 to carry a Biqu H2 V2 direct printing head. I've used this model to fit it to the carriage: https://www.thingiverse.com/thing:4799902 But then I discovered that when using this model the carriage fails to reach the X limit switch on the left side of the rails. To solve it I designed a simple solution that will close the gap while allowing you to adjust the position. I've used the freed up screw hole on the carriage and a bolt to secure it in place. I printed using Petg with 0.2 layer height and 15% infill (as it doesn't carry a lot of force or weight on it). You can also use PLA of course. I hope this helps others