Cr10s Pro Support frame

thingiverse

I've used and tested this for over a year without encountering any issues so far. However, there are still two areas that require attention. 1. You may need to use a mallet when installing M12 nuts into objects because they can be quite stubborn. 2. The iron plate at the bottom of the machine is relatively soft, which means there might be tolerances between low objects and the machine base. It's recommended to fine-tune using the first layer of the slicing software to achieve optimal results. I've done all my printing with PLA and gotten the expected results. To improve support, you may want to consider using higher padding. You'll need the following additional materials: * M12 Screw thread - at least 750MM *2 * M12 Flange nut - *8 * M3 screw - at least 8MM *4 * M4 screw - 8-9MM *4 * 2020 aluminum extruded T-slide nut - *4 For Cr10spro & Cr-x.