CR10s PRO Hero Me ABL mount for M12 sensor (Gen4 Gen3)

thingiverse

There was a minor glitch in the original Gen4 ABL mount that caused the gantry to miss the X limits switch entirely. A revised version has been uploaded to fix this issue: Gen4_Stock_ABL_mount_for_dual_5015_Duct_M12_fixed.STL. If you have already printed the first version and don't want to reprint, there's a 'patch' part that can be glued into place to resolve the problem: Gen4_Stock_ABL_mount_for_dual_5015_Duct_M12_patch.STL. Update 2020/04/29: This design has been updated specifically for Hero Me Gen4 and is optimized for dual 5015 fans. If you're using a single fan, the previous version designed for single fans should still work fine. The offset settings will be available once I've updated my Gen4 Hero Me with the latest firmware. For now, the main changes are minimal, but I'll assume it's still accurate to go ahead with this version. DISCLAIMER: This version is not yet tested on Gen4 and may require additional adjustments. Use with caution and please provide feedback! For those using or considering M12 sensors, this mount is specifically designed for your needs. Marlin firmware offsets for the Hero Me are as follows: - Single fan duct: -45 X and -9 Y - Dual 5015 fan duct: -48 X and -9 Y Note that single fan duct offsets should also work fine with dual fan ducts! **WARNING:** With TM3D Marlin 2.0 firmware, auto leveling has been updated to 5x5 points, which can cause issues during gantry calibration. To resolve this, adjust the offset values to -40 and -9 Y.