Cr10s-pro breakout board + filament sensor + cable chain mod (Crusa mod)

thingiverse

Third part of my custom mod to match the MK3's extruder on the CR-10S Pro.\r\nFind my MK3s adapter here: https://www.thingiverse.com/thing:4151703\r\n\r\nI reorganized the breakout board for easier access, securing it with a hinged door for protection.\r\n\r\nAt the same time, I added attachments for proper cable chain management on the X and Z axes. For the Z axis, I purchased new 30-pin flat cables - you'll need about 50 inches or 1.3 meters of them, along with new female plugs. This was a relatively easy process to split the flat cables every five units and then tape stack them to fit within the cable chain as seen in the pictures.\r\n\r\nThe cable chain used is a 10x10: https://www.amazon.com/gp/product/B07WDVJB8W/ref=ppx_yo_dt_b_asin_title_o00_s02?ie=UTF8&psc=1\r\n\r\nI also reworked the filament sensor using the same internal components as the Prusa MK3, featuring a steel ball for easy insertion. The switch is the original one. If you want to position your filament sensor differently, simply skip its base and cover. After printing the sensor base, you'll need to drill a 2mm hole through the top hole to clean it up.\r\n\r\nThis new filament sensor setup also features a reverse bowden attachment using an M6 connector as seen in the pictures.\r\n\r\nMost of the hardware used is the original CR-10S Pro with just a few additional M3 screws. \r\n\r\nIf you decide to do it, let me know and feel free to ask any questions you may have.