Cr10s filament spool holder triple bearing

thingiverse

Triple bearing turbo ultra-smooth filament spool holder!!! Add a piece of foam into the spool thread, as seen in the picture, in one of three holes and make it break a little just in case of filament tangle. One more important factor is to grease bearings so they won't be high speed, instead they'll have a steady nice flow. It's smooth! It supports all spool sizes up to 2.3 kilograms plus. Materials: Bearings: Two 6002 bearings and one Rollerblade bearing Fully threaded rod: 150 millimeters long, seven millimeters in diameter, fully threaded (you can get this rod from Anet A8 spool holder parts) or use a longer rod and add washers and bolts on each side if you want. Print details: ABS or PLA Infill: Thirty percent plus Layer height: 0.1 to 0.2 millimeters Cheers!