CR10S Control Box Inverted Lack Bracket

thingiverse

This is a tutorial on mounting the CR10S control box on an inverted Lack table setup, utilizing Lacks for organization. If you plan to use Lacks as an enclosure, be prepared to modify them or seek alternative solutions. Since I aimed to minimize wire extension, this method was my preferred choice. To assemble the clamp section, locate countersunk holes designed for screws at both the top and bottom. I opted for a single screw on top, which proved remarkably strong. Additionally, I applied 3M double-sided tape to the top section to prevent the control box from sliding and potentially getting lodged under the X gantry. To secure the inverted table to the one beneath it, I relied on 3M double-sided tape. By scaling down the z-height of your print job, you can significantly reduce print time. To do this, simply drill a hole for the screw in the modified clamp section.