CR10 S5 OEM Filament Tube Extension

thingiverse

The original filament tube holder that came with my CR10 S5 measured approximately 4 inches in total length, but once assembled, it wouldn't accommodate a filament roll wider than 3.25 inches. With this extension, you can easily fit a filament roll up to 4 inches wide on the holder. I've also designed extension clips as spacers for use when the rolls aren't quite as wide, allowing me to leave the extension in place. The extension's outer diameter is 1.875 inches. The larger side features a lip with an O.D. of 2.125 inches, but you can simply remove the extension and pass it through the roll before screwing the nut back into place. I used Cura 3.6.0 with standard settings (see photos) to print this item on my Creality CR10 S5, resulting in a remarkably smooth finish. You're free to slice the design however you prefer.