CR10-S Pro Frame Brace (light version)

thingiverse

This is a derivative from "Achocho's Frame Brace V2" for the Creality CR10-S Pro. Compared to the original designs, this version uses significantly less filament while maintaining strength. You will save approximately 16% of filament with each top part and more than 50% with each bottom part. And the bottom part no longer conceals the Creality logo on the front panel. Note: The holes in this version are designed for M8 threaded rods (8mm diameter). I will soon upload a new, even lighter version that includes 6mm and 10mm versions. ==================================================================== EDITED (V2) ==================================================================== A new version has been uploaded, which is even lighter and comes with three threaded rod sizes: 6mm / 8mm / 10mm. The names of the parts for this new version all end with the threaded rod diameter. Parts without a diameter in their name are V1 and are designed for an 8mm threaded rod. The bottom part has been redesigned to allow added flexibility, which is welcome. With this new version compared to the originals, you will save more than 35% of filament with each top part and over 70% with each bottom part without sacrificing rigidity. If you're unsure which version to print, I strongly recommend V2 (parts having names ending with a diameter indication). Cheers Note: YOU CAN'T MIX V1 AND V2 PARTS SO MAKE SURE TO PRINT COMPATIBLE TOPs AND BOTTOMs. The photo shows all versions: original Achocho's version (right), V1 (bottom left - black) and V2 (top left).