CR10(s) Enclosure

thingiverse

Enclosure for the CR10(S) is designed, but any printer that fits within this size can easily be placed inside. A notable aspect of the CR10(S) enclosure is its maximum print height, which stands at 32cm due to the width of the enclosure and the raised x-axes. If you want to print taller than this, simply remove the top of the enclosure or make it 3 CM wider. Unfortunately, my enclosure is already built, so I won't be able to do either. The enclosure consists of two parts: the bottom where the printer rests on and the removable top for easy maintenance or placement. The Sketchup file contains all the necessary parts that can be printed yourself, including the wooden stands, floor, sides, and MDF 12mm thick top. For sizes, please refer to the Sketchup file. I will be uploading the remaining STL files for the 3D printable parts in a few days. For the windows and door, I used polycarbonate sheets that are 3mm thick. The specifications are as follows: * Two sides: 520 x 520 mm, €25 each * One door: 408 x 495 mm, €10 Polycarbonate is highly transparent and can withstand a lot of heat. Here is the bill of materials for the printable parts: Door: 1 x CR10 enclosure door handle (0.2.stl) Hinge from: https://www.thingiverse.com/thing:1933479 2 x counter_sunk_right_hand.stl 2 x hinge_back_plate.stl 2 x pan_head_right_hand.stl 1 x Corner with 3mm hole for magnet with rounded corners.stl 1 x Screw thickening for magnet at enclosure door.stl 2 x Corner with 3mm hole for rounded corners.stl Top: 1 x CR10 enclosure inner cover.stl 1 x CR10 enclosure inner cover with pulley holder part 1 vs 1.2.stl 1 x CR10 enclosure inner cover with pulley holder part 2 vs 1.2.stl 6 x CR10 enclosure outer cover seal.stl Stands to ensure the top doesn't move: 2 x CR10 enclosure inside bracket for rear stands.stl 1 x CR10 enclosure inside bracket for front left stand.stl 1 x CR10 enclosure inside bracket for front right stand.stl Polycarbonate side: 2 x CR10 enclosure hook for polycarbonate sheet.stl 2 x CR10 enclosure polycarbonate bottom clamp.stl Bottom inside: 10 x Hook 90 degrees 12x12mm for screw with sunken head 3mm.stl 4 x Corner 90 by 90 degrees 25x25 for screw with sunken head 3mm.stl Top inside: 14 x Hook 90 degrees 12x12mm for screw with sunken head 3mm.stl 4 x Corner 90 by 90 degrees 25x25 for screw with sunken head 3mm.stl 2 x Corner 90 by 90 degrees 25x25 extra long for screw with sunken head 3mm without rounded corners.stl LED strip: 5 x LED strip bracket.stl 1 x LED strip bracket on one side only.stl Filament pully at the left back of the inside of the enclosure: 1 x Holder for filament pully part 1.stl 1 x Holder for filament pully part 2.stl 1 x Wheel 26mm vs 1.1.stl Extension cables for the electronic box can be made yourself or purchased from eBay. I extended my RaspberryPi with a power switch and LED, which can be found at https://www.thingiverse.com/thing:3399288. This enables a smooth shutdown and prevents the CR10S control unit from powering on via USB when in "shutdown - h" state.