CR10-MKS GEN 1.4 support d'adaptation boiteir

thingiverse

<h4>This support allows for the installation of an MKS GEN V1.4 card in the original case of the CR10, CR10S, and CR10 mini (CR10 mini for my realization).</h4> <h3><strong>ATTENTION:</strong> Any modification to your machine carries a risk of damage and annulation of the current warranty. You perform these modifications at your own risk.</h3> It positions itself in place of the original card mounted in the CR10 case. It requires removing the original screen because it does not allow mounting the support, with the space inside the case being too reduced. The support integrates the mounting of a fan of your choice: - The original one. - Or another quieter one. In this example, it is a noiseblocker 40mm. Drilling the holes for the fixations must be done once the piece has been printed or you can modify the 3D (I did not have the spacing of the holes for my fan, I preferred to do them after printing). Access to the USB port of the card requires drilling a hole in the side of the case. For my part, I chose to drill with a D22mm jigsaw and I will add a glued piece to properly block the hole. A drilling of 15mm seems sufficient. <h3>Conseil:</h3> For connecting the terminals, it is very difficult to do once the card is in place at the bottom of the case. I advise you therefore to do it before positioning the card on top of the case with a cardboard underneath. I added two points of glue in the bottom of the support (The 3 fixations of the support being distant from the end of the support) to avoid the card moving since it is upside down in the case.