CR10-MKS GEN 1.4 case adapter bracket

cults3d

This bracket allows you to install a MKS GEN V1.4 board in the original CR10, CR10S and CR10 mini ( CR10 mini for my realization) case. WARNING: Any modifications to your machine result in a risk of deterioration as well as the cancellation of the current warranty. You make these modifications knowingly and at your own risk. It comes in place of the original card mounted in the CR10 case. It requires the removal of the original screen because it does not allow to mount the support, the space inside the case being too small. The support integrates the mounting of a fan of your choice: original. or a quieter one. In the example it is a 40mm noiseblocker. The drilling of the fixing holes is to be done once the part is printed or you can modify the 3D (I didn't have the center distance of the holes for my fan, I preferred to do them after printing). Access to the USB port of the card requires drilling the case on the side. For my part, I chose to drill with a D22mm hole saw and I will add a glued piece to plug the hole cleanly. A 15mm diameter hole seems to be enough. Hint: For the connection of the terminals, it is very difficult to make once the board in place in the bottom of the case. So I advise you to do it before by positioning the board on the top of the case with a cardboard underneath. I added two points of glue in the bottom of the support (The 3 points of fixings of the support being them distant compared to the end of the support) in order to avoid that the card does not move since it is upside down in the case.