CR10/Ender 3 Fanduct for Stock Setup with 40mm fans

prusaprinters

<p>I designed this Fan Duct for any stock Creality CR10 or Ender3 setup, which is inspired by my Fan Duct for the MicroSwiss DirectDrive (<a href="https://www.thingiverse.com/thing:4886226">https://www.thingiverse.com/thing:4886226</a>) to increase the part cooling capabilities.<br/> .<br/> .<br/> It can be used with a full stock setup as well as the MicroSwiss AllMetalHotend.<br/> .<br/> .<br/> For easy installation and access to the hotend it consists of three parts:<br/> -The main part including the part cooling ducts and backplate<br/> -The removable front fan adapter<br/> -The removable cable guide for cable management<br/> .<br/> .<br/> It uses two 40mm Fans mounted to the sides for part cooling and another 40mm Fan mounted to the front adaptor for cooling the heatbreak/cooling block. All parts are connected with standard M3 screws.<br/> .<br/> .<br/> .<br/> V1 features:<br/> -BLTouch and 18mm probe mount on the front fan adapter (for EZABL,CR10S Probe,...)<br/> -removable cable guide for use with zip-ties<br/> -good ground clearance to avoid hitting bed clips,...<br/> -easily printable with supports set to "Touching Buildplate" in Cura<br/> .<br/> .<br/> I also included some photos for the X- and Y-offsets between the nozzle and BLTouch:<br/> .<br/> BLTouch: define NOZZLE_TO_PROBE_OFFSET {31.98 , -39.13}<br/> 18mm Probe: define NOZZLE_TO_PROBE_OFFSET {-32.69 , -45.05}<br/> .<br/> .<br/> If you decide to print the fan duct please consider posting your print as a make or if you did some changes/adjustments or added your own mounts for it, share it as a remix please, so that everybody can profit from it!</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>CR-10</p></div><strong>Rafts:</strong></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div><strong>Resolution:</strong></p> <p>0.4mm nozzle, 0.2mm layer height</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>10-25%</p></div></p> <p><strong>Notes:</strong></p> <p>Supports can be set to "Touching Buildplate" in Cura to reduce the print time!</p> </p></p></p> Category: 3D Printer Accessories