CR10 - CR10S - Ender 3 x-limit switch and filament runout mod for direct drive - For CR-10S Pro Runout Switch

thingiverse

This is a remix of [franpoli](https://www.thingiverse.com/franpoli)'s fantastic filament run-out sensor/limit switch bracket designed for the Creality CR10S, CR10 and Ender 3 with direct drive solutions.\r\n\r\nMade to accommodate the switch used in the official Creality filament sensor for the CRS-10 Pro available on websites like [AliExpress](https://www.aliexpress.com/i/33012990829.html).\r\n\r\nThis remix shifts the sensor mount to the left and rounds out the right-hand corner to make it compatible with [BoothyBoothy](https://www.thingiverse.com/BoothyBoothy)'s outstanding Hydra Fan Duct mod.\r\n\r\nDuring x-axis homing, the wire bundle used to get mashed hard into the sharp edge of the sensor box which could cause damage to the wiring over time. This fixes that problem.\r\n\r\nA couple of minor improvements include tapering screw holes to eliminate the need for supports and widening the sensor light sight hole.\r\n\r\nIf you've already made the original bracket, the existing cover piece will fit on this remix but the edges won't be perfectly flush – it's only an aesthetic issue. An updated cover is included.\r\n\r\nI've included a second version of the back piece that can accommodate M3x6mm SUS303 tapping slotted threaded inserts for better gripping of screws. The original design was very prone to stripping.