CR10 BL Touch support with cable guide for Petsfang duct

thingiverse

I needed a specific solution after installing this excellent design here: https://www.thingiverse.com/thing:2759439. As I had purchased an original BL Touch cable, 150cm long, and it was too short to follow the same path as the other hotend cables, I designed a shorter route by guiding the cable directly out of the probe to a specific guide in the support. The piece prints with "supports everywhere". A hole is present to insert a zip tie to secure the cables in the guide. The cable is then guided by an additional part on the X-axis here: https://www.thingiverse.com/thing:3737850. This setup works best when the cable is inserted into a woven cable channel similar to the ones used for the hotend cables of the CR10 printer.