CR Touch Mount Microswiss Direct Drive

thingiverse

Ender 3 and Microswiss Direct Drive Mount for CR Touch. Modled for Linear Rail should work with standard Vslot wheels as well (untested) Should also work with Ender 5 (pro) ender 3 pro Cr10 should be about the same. not likely for S1 or V2 When it arrived I found out the wires and mount are a bit different. Also the Microswiss Plate brings the nozzle down a bit from stock position. This puts the needle a bit too close for comfort!!! My offset for the Z was about -2.67 with this new mount and very worn nozzle !!! I didn't even measure the X and Y offsets... just started a print, close enough to the old one but I will update once I measure. My old settings were -39, -12 That is a ballpark, need to measure like I said!!! I printed as is with tree support, came out pretty well, you could flip it so the other face is on build plate. Only took about an hour at 80mms (40 walls as cura drops them by half, I also changed infil to 40mms) I did 4 walls, 4 top 4 bottom and 25% gyroid, came out plenty strong. *** NOTE *** You will HAVE to install mount and fan shroud to the plate BEFORE you attach the CR Touch to the mount!!!! Ensure the screw you use to attach the mount to the printer seats inside the recess of the print and is flush with surface. This is for bottom hole only. The reason for this is that I wanted the sensor as close as possible to nozzle. Doing so you can probe a bit further away from the center of the bed. If you complie your own firmware you can also increase X max travel to about 255 (test and ensure that nothing binds!!!) Then if you run a mesh it will be much closer to bed limits.