Cr Touch Clip (No Rattle)

thingiverse

This is an anti rattle clip I designed for the CR Touch. It is inspired by gileswells clip here: https://www.thingiverse.com/thing:4963132. That clip did not quite work for me, but it make work for you! It also has the added bonus of not requiring any hardware. This clip uses the 2 existing mounting points of the CR Touch probe. You will require 2 longer M3 screws and 2 M3 nuts to install it. I recommend printing at 100% infill. The bracket can be printed flat. The clip should be printed on its side with the handle pointing up and with supports turned on. It may be possible to install my bracket between the metal bracket and the CR Touch probe, using the original screws, but the screws will only be engaged by a couple threads and you will be getting very close to your print bed. You will also require a Z Offset adjustment with this method. Requirements: 1x printed bracket 1x printed clip 2x M3x10mm screws (Recommended length. You may be able to get by with 8mm. Longer is fine, I am using 12mm in the photos) 2x M3 nuts