CR-6 SE X-Axis and Z-Axis Linear Rail mount

thingiverse

It's the begin of an other linear rail mount thing for Creality CR-6 SE https://www.tinkercad.com/things/hBXwv0Hv9Iv Everything would work mechanically but there are problems with the plastic. PETG and PLA are too soft, you have to tighten all M3 and M4 screws again and again. It's not that the screws are loosening, it's that the plastic gives way over time and compresses it. What is your favorite material for such things? ####Feb 03.2022: V3.14 / V3.15 - now you can print without support-blockers and when finish you can insert and glue the magnets ####Jan 22.2022: V3.10 / V3.11 / V3.12 / V3.13 - some little adjustments and redesigns ####Jan 18.2022: some adjustments are necessary - the motor part is too weak, if the x belt has too much tension, the plastic will bend ####Jan 16.2022 / V3.05 / V3.06 / V3.07 / V3.08 / V3.09a: - 3.05: Sensor Mount - 3.06: Belt Clamp - 3.07: X-Axis Tensioner Side - 3.08: Anti Backlash and Antiwobble (need 24 6x3mm neodym) - 3.09a: X-Axis Motor Side ####Jan 15.2022 / V3.06: (not tested) - belt clamp redesigned to mount on the carriage with several spacers in 1.0, 1.5 and 2.0mm, they should be break out after print. ####Jan 12.2022 / V3.06: - belt clamp to mount on the carriage ####Jan 11.2022 / V3.04 (a,b): - linear rail mount with or without LGX-Extruder mount ####Jan 09.2022 / V3.02 / V3.03: - left side: This version is more accurate and stable. The fixed points of the switches are still missing. - right side: This version is more accurate and stable, beld tensioner must be more to left ####Jan 08.2022 / V3.00b / V3.01: the guides are still not precise enough, please do not use them yet. I'm already overworking. ####Jan 07.2022 / V3.01: - right side: next prototype, print it up side down ####Jan 06.2022 / V3.00b: - new version numbers! - left side: next prototype, print it up side down ####Jan 01.2022: (not finished) - Today i have mount all the things -> there is more work to do to fit than i thought i recommend this things: - https://www.thingiverse.com/thing:4871212 - https://www.thingiverse.com/thing:4227492 you will need: - M3 screws and nuts - threaded inserts plastic - 24 pieces 6x3mm magnets - 16 balls from 608 bearing - a longer GT2 6mm belt!