CR-6 SE to CR-5 Pro Hotend Adapter

thingiverse

Needed a replacement hotend for my CR-5 Pro, but all I could find, that was even close, was CR-6 SE hotends. Made this adapter to be able to run a CR-6 SE hotend in the CR-5 Pro. You'll need an assortment of buttonhead m3 screws and two nuts (I didn't pay attention to what length screws I used). The top adapter is pretty self explanatory, but when attempting to mount the fan to the factory location on the hotend, I found there wasn't enough clearance, when the assembly was installed, so I made the blocks to allow the fan to be mounted a bit higher. This solved the clearance issue. I did have to grind down two opposing flats on each nut, to allow them to fit between the tabs of the heatsink. The photo shows the assembled product (not as clearly as I'd prefer, but it's what I have). Printed in PLA+, and it seems to work well.