CR-6 SE Extruder Nema 17 motor cooler

thingiverse

In the city I live in, the extruder motor overheats because the temperatures rise by 40 C, the motor protects itself and I could not finish the printing. I started looking for a ready-made project suitable for the CR-6 SE to cool the Nema 17 motor. There were very good projects, but the fact that the Z axis shaft was too close to the motor was preventing it. In the projects I found, since the fan was at the bottom of the motor, the heater bed would give the incoming heat to the motor and it would not make any sense. I decided to design it myself. In my design, you can either mount it with 2mm long screws from the motor's own screws or attach it with adhesive tape like I did, or even mount it without doing anything. There is also a piece for attaching the 40x40mm fan cable to the side. I mounted it with a small triphone screw for the fan connection.