CR-10SPro 8 LED MOUNT

thingiverse

Hello, this is my first contribution to the community. A minimal 8 LED WS2812B mount for the CR-10SPro lights up your print beautifully.\r\n\r\nHow to make it:\r\n1. Print the model with the gcode, or slice it yourself with 100% infill so that the eccentric nut mount won't break easily.\r\n2. Get some WS2812B's (or other similar 5V) LEDs and stick them with double-sided tape to the two main areas.\r\n3. Solder them together as shown on underside.jpg and secure the joining wire to the side of the carriage.\r\n4. Run the three-line cable as shown on back.jpg through the main cable line, down to the extruder, and along the flat cable line to the CR-10SPro's mainboard.\r\n5. Connect your three wires to the board as shown on wiring.jpg - note that V G S markings indicate connections for the LEDs: V goes to 5V, G connects to G, and S plugs into DIN.\r\n6. Flash your firmware with changes made in configuration.h (ensure you have):\r\n#define NEOPIXEL_LED // uncommented\r\n#define NEOPIXEL_TYPE NEO_GRB \r\n #define NEOPIXEL_PIN 12\r\n #define NEOPIXEL_PIXELS 8\r\n #define NEOPIXEL_IS_SEQUENTIAL\r\n #define NEOPIXEL_BRIGHTNESS 127\r\n #define NEOPIXEL_STARTUP_TEST\r\n7. Boot up and enjoy your new LED light show!