CR-10S stock Filament Runout Detection switch holder & cleaner

thingiverse

Human: the name pretty much sums it up. uses the 3 existing screws from the run out housing that comes with your cr-10s. may require drilling a little where the filament guide is to fit the 4mm Bowden Tube perfectly and slide filament with ease. I used soundproofing foam for the cleaner. You can use any dust-free foam you see fit though. secures cable with a zip tie. attaches to the same z-rod screws as the original (DO NOT OVER TIGHTEN). ( DO NOT SUPER GLUE THE DETECTION SWITCH HOLDER TO THE CLEANER ). if you need to secure it a little better, use "tacky glue" so it can still come free if needed.