CR-10S Pro SKR Pro 1.1 Mount EEPROM USB Management

thingiverse

This is a custom mount designed specifically for the Bigtreetech SKR PRO V1.1 with an EEPROM holder and a USB breakout board. The entire design was created from scratch. Three points use the original screws from the Creality board. One point goes through a standard hole with a 10mm M3 screw. Use three M3 insert nuts. Hardware Used: Bigtreetech SKR PRO V1.1 board Four 2208 drivers, soon to be upgraded to 2209 UART Ribbon Cable Breakout Board EEPROM (AT24C256) Three M3 stock screws for attaching the mount to the chassis Four M3 10mm screws for holding the SKR and breakout PCB to the mount Three M3 insert nuts inserted directly into the mount holes V1 Mount Only: This is a basic mount without any additional features. It includes STL files for printing or STEP files for modification. EEPROM Holder: The AT24C256 EEPROM holder uses classic jumpers. The design incorporates a guide for sliding in or clicking it into place from the top. USB Breakout Board for External USB Cable: A simple micro-USB breakout board was added to the mount to utilize the original hole on the side of the frame. This connects to the host USB connection of the SKR PRO board. PCB Ribbon Cable Breakout Board Inside: This feature is also included. PCB files with Gerber will be available soon. Upcoming Features: V2 USB Mount: Coming soon PCB Ribbon Cable Breakout Board Outside: Gerber files will be available soon