CR-10S PRO Fan Duct Optimized

thingiverse

Hi everyone, This optimized fan duct for Creality CR-10S PRO 3D printer is ready for printing. For best results, print it using ABS or PETG. A support structure is required, as shown in the image above. Printing with 100% infill and a layer height of 0.2 mm will provide optimal performance. There are two versions available: a long one and a shorter version (V2). To install this fan duct, you'll need to use a longer screw, approximately 20 mm long. Be cautious not to damage the delicate fan during installation. Give it a try and share your findings. If you notice any improvement in your print results, please let me know. If your heater block is equipped with a silicon bracket, and this bracket comes into contact with the fan duct, causing melting issues, consider using V2 or simply remove the silicon bracket.