CR-10s Pro & CR-10 Max Direct drive conversion + filament guide + unload filament protection

prusaprinters

This parts can be used to utilize the existing left extruder bracket (z-bracket) and keep the setup of the filament runout sensor. It will also come with a filament guide and unload filament protection (since if you will mount the tube directly at the outlet of the runout sensor the filament will be pushed back through the sensor wich may cause some damage to the micro switch inside).Partlist:6x M3x8-104x M3x18 (will replace original runout sensor bolts)4x M3 nutM3 washers (depending on the used bolts to compensate for length1x PC4-M6 fitting1x 608 bearing (you can also choose a non bearing roller, but I recommend to use the bearing)