CR-10s bed testing

thingiverse

A simple set of 5 twenty-by-twenty millimeter tiles is placed approximately over the height adjustment points on the CR10s and in the middle of the bed. If you slice this, you should print single-layer squares that allow you to confirm your bed is level. At a given corner, if the layer is too thin, lower the bed in that corner; if the surface is bumpy, raise the bed in that corner. If your corners are okay, but the center is no good, you either need to realign your other axes relative to the bed or change your bed. Twenty-seven/March/2020: A user requested mylevel_test_5_squares_full_line.stl, so I added it.