CR-10S 400/500 Y-Axis Stepper Brace

thingiverse

This is a remix from Hamkers bracket for the regular CR-10s. The S400 has two bed cross supports that got in the way of the original bracket. The S400/S500 Y-axis stepper motor is also positioned closer to the frame, so this bracket takes that into account. Without the brace, I noticed my Y stepper motor was significantly angled away from the frame after tightening the belts. This caused the belt gear to be at an angle too, and I experienced ringing on my prints due to the stepper moving a bit when the build plate changed directions. This bracket fixes all those issues completely. I created two versions: one short, one long. Both should work just fine, so it's up to you which one you prefer better.