CR-10 V3 Upgraded Part and HotEnd Cooling Titan Direct Drive

thingiverse

I made this for my personal use and maybe it could be useful for some of you. I am no designer, engineer or expert designing parts for 3d printers, I just adjusted the original parts design by DaVinci2000 to make them work with the Creality CR-10 V3 using the stock parts it comes with. If you find this useful you can always buy me a coffee to help me stay awake and do more stuff for you: https://www.buymeacoffee.com/acorral What I changed from original design by DaVinci2000: 1.- Fitted a larger 40mm hot-end fan to be able to use the original CR10 V3 fan. 2.- Made some adjustment on the lower part of the fan mount from the inside so it can accommodate the silicon cover for the nozzle block. 3.- Fused together the nozzle and the adjustable stick on one part, I tried it first as original but as I am using ABS one part shrink much more than the other making the fitting a problem, o I just fused them together in one piece. 4.- Changed the mounting holes for them to be just a hole and once printed you can use M3 screw inserts instead of using huts and nut holders. 5. Added a bracket for holding the E3D V6 HotEnd to the CR10 V3 gantry plate, it can only be held on one side as the hole for the other side hits where the fan is. You still use all the original screws included on the original mount, just repurposed 1 of the large screws for the original gantry now is used on the fan clip and you just need to add an additional M3 nut. For the hotend base/bracket you will need extra m3 screws. The fan shroud and hotend clip must be printed in its original position, if placed vertical the strength will not be enough I printed them solid and with rafts to avoid elephants foot but it all depends on the material and the rest of your settings.