CR-10 v3 Spool Holder Riser Block

thingiverse

After relocating the filament sensor with [Thing:4716497](https://www.thingiverse.com/thing:4716497) I wanted to raise the spool to maximize the potential printing height. Since I was no longer using the filament sensor bracket I opted to make this interface block to go between the stock spool bracket and the filament bracket. This adds 35mm between the brackets, but could easily be modified to provide more or less height should you choose to do so. This design makes use of two M4 SHCS fasteners, two M4 nuts, and four M3 heatset inserts. I don't know about your machine, but Creality sent me some M4 screws that were too long to properly tighten the brackets against the 2020 extrusion, so I also replaced the M4s that interface to the extrusion T-nuts.