CR-10 v3 Hero Me Gen5/6 Adapters

thingiverse

**UPDATE 2022-06-03:** I updated the Gantry adapter and the Titan Holder to use Heat Inserts similar to how the Hero Me Gen 6 parts do. I had to thicken a portion of the Titan holder so that the inserts would have enough material to "melt" into without getting in the way of the fitment on the gantry. This makes attaching the screws so much easier than dealing with the small M3 nuts. You should be able to use any 2 holes on each side (or even opposite sides) for the inserts; Although using the ones that are closest to the heatsink are likely the best choices to use screws through the backside of the gantry. You should be familiar already with the heat inserts if you are working with the Hero Me Gen6 parts, however if you need a refresher you can use either one of the links below to get the right inserts: _Inserts with Soldering Tip:_ https://www.amazon.com/gp/product/B08BJD3W4X _Large bag of Inserts:_ https://www.amazon.com/gp/product/B08T7M2H4S I have tested fitment of the Inserts into the parts, but I haven't torn apart my machine to validate that they work. I don't see why they wouldn't considering that dimensionally everything is the same, but I want to be as transparent as possible. Please leave any and all feedback as a comment. I am leaving the original versions on this "thing" just in case you don't want to use the insert versions. **Original Post:** Sukron made a really nice remix to allow you to use the Hero Me system on a CR10v3. This is a remix of his work at: https://www.thingiverse.com/thing:4929232 I noticed that his remix had pieces that didn't join well specifically on the Titan Holder. This remix fixes that and adds a bit more support on the bottom side of the Titan Holder as well. Otherwise, for now the Gantry Adapter and Titan Adapter remain unchanged. You can use the Stock location for BLTouch or CRTouch. The fan ducts of the Hero Me Gen 5/6 clear the ABL probe using both the stock 5015 size blower as well as a larger 5020 blower. I also found that the Titan Holder can get pretty hot and actually bend\flex if you don't print it with more Temperature Resistant filament. PLA and PLA+ wont work. Please print with PETG or ABS (I only tested with ABS) Keep in mind this will also require you to cut a new PTFE tube. I use the Slice Copperhead Heatbrake in mine and that required a Capricorn tube that was 87mm long. Here is what I printed from the Gen6: HMG6_Base_E3DV6-Revo_Six-Spider-BMO (Base) HMG6 Universal collar (Collar) 5015_Single_Radial_Fan_Dual_Ducts (Fan Ducts) **NOTE** I later upgraded to a 5020 fan and it also works fine. Here are the screws I needed for this: 2x M3x16 for Collar to Base 4x M3x8 for Gantry Adapter to Base 3x M3x12 for Gantry Adapter to Gantry (Also 3x M3 Washers and 3x M3 nuts) 2x M3x12 for Titan Adapter to Gantry (Also 2x M3 washers and 2x M3 nuts) 2x M3x8 and 2x M3x12 for 5015 Fan duct to Base 1x M3x20 for 5015 part cooling fan (also 1x M3 nut or press another heat set into the fan duct screw opening) 4x M3x16 for Noctua 40x20 fan to Base (You will need shorter ones if you are still using stock cooling fan)