CR-10 v3 Filament Sensor Guide

cults3d

This is a Filament guide for the CR-V3 which goes on top of the filament sensor. It helps aligning the filament into the sensor, as the sensor has sharp corners where the filament can scratch and create particles. Would recommend using PETG as there is some stress on the part. PLA could work, too but I haven't tested it. You will need a 608 bearing and a 3 mm screw (or sth else of the same diameter) to lock the axle in place from the top. This part doesn't have to be screwed in at all. It's just a locking mechanism, so the axle won't fall out. 3D printed parts list: 1 Pin 1 Mount 2* Side You can see more details of this part in my video about the CR-10 v3: https://youtu.be/cT5pjpX8q60?t=756