CR-10 V2 Filament Guide Fastened

thingiverse

I printed this up a couple of weeks ago, and I'm finally posting it today. I really like the simple filament guide design by jschaftenaar: https://www.thingiverse.com/thing:4082933 But I wanted to secure it in place, so I used the mounting hole on my CR-10 V2's x gantry extruder frame and an M3 8-10mm screw to fasten it down. To make sure it stays put, I also created a loop that wraps around the filament sensor casing. This design works with or without a ptfe tube. I added some extra versions too: one without the loop (just the fastening hole and block), and another without the fastening hole (just the loop and block). The latter version might be compatible with any Creality filament sensor using the same enclosure/casing.