CR-10 V2

thingiverse

The CR10-V2 Wire Guide provides comprehensive information on connecting your printer's motor and endstop wires. Firstly, ensure all electrical components are disconnected from power sources before starting any wiring process to avoid potential injuries or damage to the equipment. Next, identify the various wire connectors on your CR10-V2: Motor Stepper A/B, Motor Stepper C/D, Z-Stepper, Extruder Fan, Heat Bed, and Endstops. Begin by connecting the motor wires. Connect the Motor Stepper A/B wires to the mainboard's X-Axis stepper connector (J4) and connect the Motor Stepper C/D wires to the Y-axis stepper connector (J5). Ensure correct orientation of the connectors. Now, move on to the Z-Stepper. Connect its wire to the Z-Axis stepper connector (J6). Next up is the extruder fan. Its wire should be connected to the mainboard's Fan 0 connector (J10). The heat bed wire must be connected to the mainboard's Heat Bed connector (J12). Finally, connect the endstop wires. The X-Min and X-Plus Endstops are typically connected to the mainboard's Y-Min and Y-Plus connectors, while the Z-Min and Z-Plus Endstops are usually connected to the mainboard's Z-Min and Z-Plus connectors. After completing all wiring connections, power up your printer and verify that all motors are functioning properly before resuming any printing operations.