CR-10 Standalone Kit Add onParts

thingiverse

Add on Parts for the CR-10. I wanted my cables, SD card and USB accessible from the outside of the printer instead of having to lift up the print to access everything. The SD card and USB base will need supports. This allows you to access your USB and SD card from the side of the printer if you get the USB extensions and SD-Card Extension (I got mine here: https://www.ebay.com/itm/Mini-USB-5-Pin-Male-to-Female-with-Screw-Hole-Panel-Mount-Extention-Cable-B106/182813497719?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649 https://www.ebay.com/itm/Flex-Extension-Cable-Extender-Adapter-TF-to-Micro-SD-card/173198380715?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649). The second part is for the extruder cable and bed cable. This also holds the Mosfet for the heater bed. There are holes for mounting the 50mm fan above the mosfet if desired. There's also a spot to run cables under if so desired. It won't run all of the cables, but quite a few of them. I printed and added these to my printer, but due to variations in CR-10s out there, this setup might not be perfect for you. I would attach files so you could edit them, but this was all made in tinkercad. Both models have double mounting holes so wherever you place it on the printer it should fit. I may try to make more or adjustments if need be. If you have suggestions, feel free to contact me. REVISION: 3/24/18 1:05 PM: I finally got my SD card reader in and it's way smaller than the measurements I got. I assume the measurements I got were for a full-size SD card extension. So I revised the SD card foot. 3/24/18 3:01 PM: Decided to remove the SD foot part to revise it again and make it better. Will upload a new one once it's complete. 3/24/18 10:30 PM: Added revised foot and photos.