CR-10 Standalone Kit Add onParts

cults3d

Add on Parts for the CR-10. I wanted my cables,SD card and USB accessible from the outside of the printer instead of having to lift up the print to access everything. The SD card and USB base will need supports. This will allow you to access your USB and SD card from the side of the printer if you get the USB extensions and SD-Card Extension (I got mine here: https://www.ebay.com/itm/Mini-USB-5-Pin-Male-to-Female-with-Screw-Hole-Panel-Mount-Extention-Cable-B106/182813497719?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649 https://www.ebay.com/itm/Flex-Extension-Cable-Extender-Adapter-TF-to-Micro-SD-card/173198380715?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649 ) . The second part is for the extruder cable and bed cable. this will also hold the Mosfet for the heater bed. There are holes for mounting the 50mm fan above the mosfet it so desired. There is also a spot to run cables under if so desired. It won't run all of the cables, but quite a few of them. I printed and added these to my printer but due to the variations of CR-10s out there, this setup might not be perfect for you. I would attach files so you could edit them but this was all made in tinkercad. Both models have double mounting holes so wherever you place it on the printer it should fit. I may try to make more or adjustments if need be. If you have suggestions, feel free to contact me. REVISION: 3/24/18 1:05 PM: I finally got my SD card reader in and it is way smaller than the measurements I got. I assume the measurements I got was for a full size SD card extension. So I revised the SD card Foot. 3/24/18 3:01 PM: Decided to remove the SD foot part to revise it again and make it better. Will upload a new one once its complete. 3/24/18 10:30 PM: Added revised foot and photos.